Wire Rope Grease Lubrication Systems
Designed to apply NLGI: #0, #1, #2 wire rope greases.
CoreLube's grease applicators are designed to inject grease to the core of the wire rope.
Flow Chart Information
Fits up to 1.625"-- 41.mm Wire Ropes
Fits up to 2.562"-- 65.mm Wire Ropes
Fits up to 5" -- 127.mm Wire Ropes
A-1200-LB3 System Pump
A-1600-LB3 System Pump
A-1600-LB4 System Pump
16 kg Container
55 kg Drum
180 kg Drum
Metal to Metal Contact with O-Ring Seals
Guide Bushing / Scraper
Wire Rope Grease System Features
CoreLube grease collars are extremely strong, machined from solid aluminum, not a brittle weak casting.
The collar has two inlet ports for maximum volume and coverage.
The large inlet chamber allows the grease to penetrate into the wire rope at higher speeds. (See Fig. 1)
The collar has a metal to metal contact with o-rings seals to contain high pressure. (See Fig. 4)
The collar has six swing bolts to clamp the collar tightly together to contain pressure.
Our grease pumps have a large 4.25” air motor to deliver a high volume output. This enables the wire rope to be lubricated at faster speeds. (See Fig. 2)
The scraper guide bushings remove surface contaminates of the wire rope. All bushings are machined to the diameter of the wire rope for maximum surface cleaning. (See Fig. 5)
The scraper guide bushings snap quickly into place without tools. There are no bolts or metal plates to deal with.
The scraper guide bushings extend the seal life by centering the wire rope through the seal.
The grease seals are made from high wear resistant polyurethane. (See Fig. 3)
Don’t be misled by the high pressure 50:1 ratio grease pump pressure as this will not be the pressure in the collar.
Go to: Grease Penetration for more information.
Recommended Pressure Gauge
CORELUBE’S NEW DESIGNS MAKE WIRE ROPE LUBRICATION QUICK & EASY.
Phone # 1 403-529-9645 E-mail: